Energy performance certificate (EPC)
Certificate contents
Flat 4
2, Guild Street
STRATFORD-UPON-AVON
CV37 6QZ
Valid until 10 May 2028
9498-0006-7295-5678-9964
- Property type
- Mid-floor flat
- Total floor area
- 58 square metres
Rules on letting this property
Properties can be rented if they have an energy rating from A to E.
If the property is rated F or G, it cannot be let, unless an exemption has been registered. You can read guidance for landlords on the regulations and exemptions.
Energy efficiency rating for this property
This property’s current energy rating is E. It has the potential to be C.
See how to improve this property’s energy performance.
The graph shows this property’s current and potential energy efficiency.
Properties are given a rating from A (most efficient) to G (least efficient).
Properties are also given a score. The higher this number, the lower your carbon dioxide (CO2) emissions are likely to be.
The average energy rating and score for a property in England and Wales are D (60).
Breakdown of property’s energy performance
This section shows the energy performance for features of this property. The assessment does not consider the condition of a feature and how well it is working.
Each feature is assessed as one of the following:
- very good (most efficient)
- good
- average
- poor
- very poor (least efficient)
When the description says 'assumed', it means that the feature could not be inspected and an assumption has been made based on the property’s age and type.
| Feature | Description | Rating |
|---|---|---|
| Wall | Solid brick, as built, no insulation (assumed) | Very poor |
| Window | Single glazed | Very poor |
| Main heating | Room heaters, electric | Very poor |
| Main heating control | Programmer and appliance thermostats | Good |
| Hot water | Community scheme | Good |
| Lighting | Low energy lighting in all fixed outlets | Very good |
| Roof | (another dwelling above) | N/A |
| Floor | (another dwelling below) | N/A |
| Secondary heating | None | N/A |
Primary energy use
The primary energy use for this property per year is 355 kilowatt hours per square metre (kWh/m2).
What is primary energy use?
Primary energy use is a measure of the energy required for lighting, heating and hot water in a property. The calculation includes:
- the efficiency of the property’s heating system
- power station efficiency for electricity
- the energy used to produce the fuel and deliver it to the property
Environmental impact of this property
One of the biggest contributors to climate change is carbon dioxide (CO2). The energy used for heating, lighting and power in our homes produces over a quarter of the UK’s CO2 emissions.
- An average household produces
- 6 tonnes of CO2
- This property produces
- 3.5 tonnes of CO2
- This property’s potential production
- 1.8 tonnes of CO2
By making the recommended changes, you could reduce this property’s CO2 emissions by 1.7 tonnes per year. This will help to protect the environment.
Environmental impact ratings are based on assumptions about average occupancy and energy use. They may not reflect how energy is consumed by the people living at the property.
How to improve this property’s energy performance
Making any of the recommended changes will improve this property’s energy efficiency.
If you make all of the recommended changes, this will improve the property’s energy rating and score from E (52) to C (79).
What is an energy rating?
Properties are given a rating from A (most efficient) to G (least efficient).
Properties are also given a score. The higher this number, the lower your CO2 emissions are likely to be.
Recommendation 1: Internal or external wall insulation
Internal or external wall insulation
- Typical installation cost
- £4,000 - £14,000
- Typical yearly saving
- £369
- Potential rating after carrying out recommendation 1
Recommendation 2: High heat retention storage heaters
High heat retention storage heaters
- Typical installation cost
- £1,600 - £2,400
- Typical yearly saving
- £125
- Potential rating after carrying out recommendations 1 and 2
Recommendation 3: Double glazed windows
Replace single glazed windows with low-E double glazed windows
- Typical installation cost
- £3,300 - £6,500
- Typical yearly saving
- £87
- Potential rating after carrying out recommendations 1 to 3
Paying for energy improvements
Estimated energy use and potential savings
- Estimated yearly energy cost for this property
- £972
- Potential saving
- £581
The estimated cost shows how much the average household would spend in this property for heating, lighting and hot water. It is not based on how energy is used by the people living at the property.
The estimated saving is based on making all of the recommendations in how to improve this property’s energy performance.
For advice on how to reduce your energy bills visit Simple Energy Advice.
Heating use in this property
Heating a property usually makes up the majority of energy costs.
Estimated energy used to heat this property
- Space heating
- 4070.0 kWh per year
- Water heating
- 4046.0 kWh per year
| Type of insulation | Amount of energy saved |
|---|---|
| Solid wall insulation | 2286 kWh per year |
You might be able to receive Renewable Heat Incentive payments. This will help to reduce carbon emissions by replacing your existing heating system with one that generates renewable heat. The estimated energy required for space and water heating will form the basis of the payments.
Contacting the assessor and accreditation scheme
This EPC was created by a qualified energy assessor.
If you are unhappy about your property’s energy assessment or certificate, you can complain to the assessor directly.
If you are still unhappy after contacting the assessor, you should contact the assessor’s accreditation scheme.
Accreditation schemes are appointed by the government to ensure that assessors are qualified to carry out EPC assessments.
Assessor contact details
- Assessor’s name
- Timothy McMahon
- Telephone
- 07799118469
- hippotim@gmail.com
Accreditation scheme contact details
- Accreditation scheme
- ECMK
- Assessor ID
- ECMK300978
- Telephone
- 0333 123 1418
- info@ecmk.co.uk
Assessment details
- Assessor’s declaration
- No related party
- Date of assessment
- 11 May 2018
- Date of certificate
- 11 May 2018
- Type of assessment
-
RdSAP
RdSAP (Reduced data Standard Assessment Procedure) is a method used to assess and compare the energy and environmental performance of properties in the UK. It uses a site visit and survey of the property to calculate energy performance.
This type of assessment can be carried out on properties built before 1 April 2008 in England and Wales, and 30 September 2008 in Northern Ireland. It can also be used for newer properties, as long as they have a previous SAP assessment, which uses detailed information about the property’s construction to calculate energy performance.
Other certificates for this property
If you are aware of previous certificates for this property and they are not listed here, please contact us at mhclg.digital-services@communities.gov.uk, or call our helpdesk on 020 3829 0748.
There are no related certificates for this property.